minor rust repair recommendations

[csangster]

I have a 1994 F350 that has some extremely minor bubbles and rust appearing around the rear fenderwells. What is the best way to get this under control and repaired before it becomes a cancer spot?

Recommendations on good shops that can do this? Or is this something that I can do in my driveway?

Please advise,
Chris

[74BuckinBronc]

It's likely coming from the inside, can you look at the back of the panel? There are some stop rust products, but I don't know the BEST thing to do.

J.D.

[CSP]

There's nothing minor about bubbles, especially on a wheel well where the rust starts from behind.

[csangster]

There's nothing minor about bubbles, especially on a wheel well where the rust starts from behind.

Understood, but I have already taken a good look around and there is not cancerous rust in the area, it does not appear to be starting from behind.

I just want to get it fixed before it gets any worse.

Recommendations?

[74BuckinBronc]

I would think you'll have to sand it down until the rust is gone and repaint, but I'm not a body man.

J.D.

[csangster]

I would think you'll have to sand it down until the rust is gone and repaint, but I'm not a body man.

J.D.

You are dead on. The oxides need to be completely removed to stop the propogation of rust. I think am going to use the POR-15 products to fix this area.

I was merely asking my question to see what everyones past experience has been; recommendations on methodology, products to use, etc.

As an example:
Perhaps someone had the same condition as I, sanded down the area, prime/paint it and it ended up getting worse, not better because they didn't prep the area good enough and use the proper sealants/paints.

Regards,
Chris